PCI 2 Port Serial ATA PCI RAID Host Card

This SATA PCI card is compliant with Serial ATA 1.0 specifications to upgrade your desktop for Dual Serial ATA RAID channels and one parallel ATA (IDE) host controller for supporting a single IDE channel (2 devices).

The PCI card provides up to 33/66 MHz, fully compliant Serial ATA ports on the device side to access Serial ATA hard disk drive. Striping (RAID 0) and Mirroring (RAID 1) improve the data performance and provide the data redundancy.

Features:
Serial ATA - 1.5 Gbps (150 MB/s)
Compliant with Serial ATA 1.0 Specification
Supports 48-bit LBA (Large Disk), hard drives larger than 137 GB
Supports spread spectrum clocking to reduce EMI
Registers as compatible with Parallel ATA
Single, digital PLL architecture with 1 PLL for both channels

Serial ATA Interface:
Supports SATA 1.0 (High Speed Serialised AT Attachment, Revision 1.0), 1.5 Gb/s data rate
Completely software transparent with Parallel ATA
Supports Host adaptor register Interface (SCR, Status and Control Registers)
Supports 48-bit LBA (Large Disk), hard drives larger than 137 GB

Parallel ATA Interface:
Supports Ultra DMA Mode transfers up to Mode 6 Timing (133 Mbytes/sec)
Supports 48-bit LBA (Large Disk), hard drives larger than 137 GB
Supports PIO Modes up to Mode 4 Timings, and Multiword DMA Mode 0,1,2 with Independent Timing of up to 2 drives
Supports Tri-State IDE Signals

PCI Bus Interface:
32-bit, 33/66 MHz
PCI 2.2 compliant

Operating Systems:
Windows 2000, XP and Vista